What you may be noticing
Compare normal operation with the change you first noticed. Identify what still works, when the symptom began and whether it affects one function or the whole appliance.
- An unusual run-time or cycling pattern.
- Ice building up where the drawer meets the cabinet.
- Food softening despite a low selected temperature.
- A heavy frost patch near a door or drawer.
- An alarm that returns after it is acknowledged.
Start with the change
A frost pattern is evidence to describe, rather than a part diagnosis. Frost around a gasket presents a different starting point from a cabinet that warms without visible ice.
Describe the Thermador cooking, refrigeration, wine-storage or dishwashing appliance and any custom panels or access restrictions. Standalone Thermador ice-maker service is not included in this site’s service list.
What the inspection needs to establish
The technician adapts the inspection to the installation and reported behavior. These are areas to evaluate, not a list of parts to replace.
- Compare reported temperature changes and alarm timing.
- Inspect sealing surfaces, drawer travel and airflow.
- Test the applicable fan, defrost, sensor and control circuits.
- Investigate cooling-system performance when supported by the earlier checks.
Before the visit
Keep the compartment closed and arrange suitable alternative frozen storage if it cannot maintain safe conditions. Do not chip ice with a sharp tool, apply a heat gun or remove internal panels.
Clear a safe working area, keep any displayed message and mention custom panels or restricted access. Do not dismantle the appliance in preparation.
Diagnosis, approval and repair
The diagnostic/service call is $149, credited toward an approved repair. After diagnosis, you receive an itemized repair quote before work begins. Genuine OEM parts are used.
Availability, including same-day or emergency requests, depends on the address and schedule. Sending a request does not reserve an appointment.
The 1-Year Parts & Labor Warranty covers parts installed and labor performed under normal use. It excludes new unrelated faults, misuse, power surges and work performed by others after the visit.
Sealed-system and refrigerant work is performed by an EPA-certified technician. Manufacturer names identify equipment serviced; this is independent service.
